Dog Doorbell Installation Instructions
Single use pack of adhesive now included!
A clean and smooth surface will ensure the ease of installation!!
Items Needed: screwdriver, tape
1. Remove the existing doorbell from home and disconnect the two wires.
2. Place supplied adhesive (E6000 made by GOOP) on
back of doorbell avoiding overlapping the adhesive and the backing tape.
3. Let the adhesive set up for about one to two minutes and attach the
wires to the contacts on the new button...does not matter which wire on which
contact.
4. Remove the backing paper from the backing tape. Press the stone
against the wall so that the backing tape makes solid contact and allow adhesive
to dry.**
** If inadequate contact is made to hold the doorbell in place while the
adhesive dries, use blue painters tape or masking tape to hold it.
CONGRATULATIONS!!! Your entry is now complete!